S55YRK-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S55YRK-7. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vcc*	WiFi*
1788568220	11.8 V	-34 dBm
1788567681	11.8 V	-34 dBm
1788567081	11.8 V	-34 dBm
1788566481	11.8 V	-34 dBm
1788565881	11.8 V	-35 dBm
1788565281	11.8 V	-34 dBm
1788564620	11.8 V	-34 dBm
1788564021	11.8 V	-34 dBm
1788563481	11.8 V	-34 dBm
1788559220	11.8 V	-33 dBm
1788558620	11.8 V	-34 dBm
1788558021	11.8 V	-34 dBm
1788557420	11.8 V	-34 dBm
1788556881	11.8 V	-34 dBm
1788556281	11.8 V	-34 dBm
1788555681	11.8 V	-34 dBm
1788555081	11.8 V	-35 dBm
1788554420	11.8 V	-35 dBm
1788553821	11.8 V	-34 dBm
1788553280	11.8 V	-34 dBm
1788552620	11.8 V	-34 dBm
1788552080	11.8 V	-34 dBm
1788551481	11.8 V	-34 dBm
1788550821	11.8 V	-34 dBm
1788550221	11.8 V	-35 dBm

*Used Equation Coefficients:

Vcc: 0, 1, 0

WiFi: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)