SP3KON-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KON-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773169606	306 Count	648 Count	116 Count
1773168705	304 Count	641 Count	115 Count
1773167804	302 Count	636 Count	114 Count
1773166904	300 Count	632 Count	113 Count
1773166002	298 Count	627 Count	112 Count
1773165101	297 Count	625 Count	112 Count
1773164200	295 Count	619 Count	111 Count
1773033772	294 Count	619 Count	111 Count
1773032871	291 Count	603 Count	109 Count
1773031971	287 Count	592 Count	106 Count
1773031070	284 Count	582 Count	104 Count
1773030169	280 Count	573 Count	101 Count
1773029268	277 Count	561 Count	99 Count
1773028367	275 Count	553 Count	98 Count
1773027466	272 Count	541 Count	96 Count
1773026565	269 Count	531 Count	94 Count
1773025664	265 Count	518 Count	91 Count
1773024762	262 Count	510 Count	89 Count
1773023862	259 Count	501 Count	87 Count
1773022961	256 Count	492 Count	85 Count
1773022060	251 Count	477 Count	81 Count
1773021161	248 Count	469 Count	79 Count
1773020280	245 Count	460 Count	77 Count
1773019379	241 Count	449 Count	74 Count
1773018478	238 Count	438 Count	72 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)