SQ9PD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772639370	74 Count	854 Count	49 Count
1772638469	71 Count	825 Count	47 Count
1772637569	66 Count	769 Count	43 Count
1772636690	65 Count	742 Count	43 Count
1772635767	64 Count	735 Count	43 Count
1772634867	61 Count	680 Count	41 Count
1772633966	60 Count	672 Count	41 Count
1772633065	59 Count	666 Count	41 Count
1772632165	55 Count	599 Count	38 Count
1772631264	51 Count	509 Count	35 Count
1772630363	47 Count	422 Count	32 Count
1772629501	42 Count	416 Count	32 Count
1772628578	41 Count	405 Count	32 Count
1772627677	37 Count	328 Count	29 Count
1772626777	32 Count	287 Count	25 Count
1772625875	28 Count	253 Count	22 Count
1772624975	25 Count	196 Count	20 Count
1772624074	21 Count	175 Count	17 Count
1772623185	17 Count	136 Count	14 Count
1772622272	13 Count	102 Count	11 Count
1772621372	7 Count	55 Count	6 Count
1772620471	4 Count	38 Count	4 Count
1772619594	113 Count	1049 Count	85 Count
1772618670	108 Count	977 Count	81 Count
1772617769	103 Count	921 Count	77 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)