SV5BYP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV5BYP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	V_Bat*
1777531419	40 Count	5.75 VDC
1777531356	39 Count	6.88 VDC
1777531293	38 Count	6.88 VDC
1777531230	37 Count	6.88 VDC
1777531167	36 Count	6.88 VDC
1777531104	35 Count	6.88 VDC
1777531041	34 Count	6.88 VDC
1777530977	33 Count	6.88 VDC
1777530914	32 Count	6.88 VDC
1777530851	31 Count	6.88 VDC
1777530788	30 Count	6.88 VDC
1777530725	29 Count	6.88 VDC
1777530662	28 Count	6.88 VDC
1777530599	27 Count	6.88 VDC
1777530536	26 Count	6.88 VDC
1777530473	25 Count	6.7 VDC
1777530410	24 Count	6.39 VDC
1777530347	23 Count	5.93 VDC
1777530284	22 Count	5.68 VDC
1777530221	21 Count	5.33 VDC
1777530157	20 Count	5.08 VDC
1777530094	19 Count	4.82 VDC
1777530031	18 Count	4.56 VDC
1777529968	17 Count	4.24 VDC
1777529905	16 Count	3.99 VDC

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)