SQ2LXR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2LXR-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1762353545	156 Count	502 Count	100 Count
1762353323	153 Count	498 Count	100 Count
1762353261	152 Count	498 Count	100 Count
1762351739	149 Count	498 Count	100 Count
1762322491	137 Count	498 Count	100 Count
1762295540	134 Count	498 Count	100 Count
1762293734	133 Count	498 Count	100 Count
1762291929	132 Count	498 Count	100 Count
1762288319	130 Count	498 Count	100 Count
1762286515	129 Count	498 Count	100 Count
1762281121	126 Count	498 Count	100 Count
1762268917	118 Count	498 Count	100 Count
1762268839	117 Count	498 Count	100 Count
1762268810	116 Count	498 Count	100 Count
1762266773	87 Count	437 Count	77 Count
1762264972	77 Count	394 Count	68 Count
1762263171	72 Count	359 Count	64 Count
1762261370	66 Count	322 Count	59 Count
1762257769	53 Count	250 Count	48 Count
1762255968	25 Count	161 Count	21 Count
1762254177	17 Count	127 Count	14 Count
1762252376	12 Count	98 Count	10 Count
1762250575	7 Count	65 Count	6 Count
1762248774	3 Count	30 Count	3 Count
1762246973	129 Count	1048 Count	91 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)