SR8MBR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8MBR-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1788453013	885 Count	684 Count
1788452968	885 Count	684 Count
1788448688	885 Count	684 Count
1788448524	885 Count	684 Count
1788448126	885 Count	684 Count
1788444526	885 Count	684 Count
1788440916	838 Count	684 Count
1788437316	794 Count	684 Count
1788433716	747 Count	684 Count
1788430116	702 Count	684 Count
1788426516	656 Count	677 Count
1788422916	588 Count	591 Count
1788419316	536 Count	565 Count
1788415716	488 Count	557 Count
1788412116	441 Count	554 Count
1788408516	383 Count	515 Count
1788404915	307 Count	408 Count
1788401314	239 Count	329 Count
1788397717	162 Count	234 Count
1788394116	88 Count	122 Count
1788390515	752 Count	1166 Count
1788386914	641 Count	995 Count
1788383314	523 Count	753 Count
1788379713	451 Count	657 Count
1788376115	377 Count	571 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)