SQ1BHQ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ1BHQ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1776690730	910 Count	184 Count	123 Count
1776688929	901 Count	184 Count	123 Count
1776687128	893 Count	184 Count	123 Count
1776685328	884 Count	184 Count	123 Count
1776683527	876 Count	184 Count	123 Count
1776681726	867 Count	184 Count	123 Count
1776679926	859 Count	184 Count	123 Count
1776678125	851 Count	184 Count	123 Count
1776676324	842 Count	184 Count	123 Count
1776674523	827 Count	177 Count	116 Count
1776672723	816 Count	174 Count	113 Count
1776660160	814 Count	174 Count	113 Count
1776658360	805 Count	173 Count	112 Count
1776656569	794 Count	171 Count	110 Count
1776654768	782 Count	167 Count	106 Count
1776652967	774 Count	167 Count	106 Count
1776651169	762 Count	165 Count	104 Count
1776649365	749 Count	163 Count	102 Count
1776647565	736 Count	161 Count	100 Count
1776645764	724 Count	159 Count	98 Count
1776643963	710 Count	157 Count	96 Count
1776642162	697 Count	155 Count	94 Count
1776640361	684 Count	153 Count	92 Count
1776638561	670 Count	151 Count	90 Count
1776636760	657 Count	149 Count	88 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)