SR1NRD-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR1NRD-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765501365	737 Count	75 Count
1765500764	736 Count	75 Count
1765500163	735 Count	75 Count
1765499563	734 Count	75 Count
1765498962	733 Count	75 Count
1765498361	732 Count	75 Count
1765497760	731 Count	75 Count
1765497159	730 Count	75 Count
1765495968	728 Count	75 Count
1765495357	727 Count	75 Count
1765494757	726 Count	75 Count
1765494156	725 Count	75 Count
1765493555	724 Count	75 Count
1765492954	723 Count	75 Count
1765492354	722 Count	75 Count
1765491753	721 Count	75 Count
1765491152	720 Count	75 Count
1765490551	719 Count	75 Count
1765489950	718 Count	75 Count
1765488773	716 Count	75 Count
1765488173	715 Count	75 Count
1765487572	714 Count	75 Count
1765486971	713 Count	75 Count
1765486371	712 Count	75 Count
1765485770	711 Count	75 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)