SQ8PDY-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8PDY-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773337283	1 Count	11 Count	1 Count
1773335482	218 Count	1057 Count	192 Count
1773333681	206 Count	963 Count	181 Count
1773331881	195 Count	872 Count	171 Count
1773330080	181 Count	774 Count	158 Count
1773326479	175 Count	747 Count	154 Count
1773324678	166 Count	693 Count	146 Count
1773322884	160 Count	691 Count	145 Count
1773321083	144 Count	627 Count	130 Count
1773319282	135 Count	585 Count	122 Count
1773317482	134 Count	581 Count	122 Count
1773315681	123 Count	508 Count	112 Count
1773313881	100 Count	370 Count	90 Count
1773312080	68 Count	280 Count	59 Count
1773310279	60 Count	234 Count	52 Count
1773308479	44 Count	190 Count	37 Count
1773306678	34 Count	151 Count	28 Count
1773304877	26 Count	116 Count	21 Count
1773303077	19 Count	76 Count	15 Count
1773301282	226 Count	1048 Count	209 Count
1773299482	210 Count	957 Count	194 Count
1773297681	198 Count	897 Count	183 Count
1773295880	187 Count	830 Count	173 Count
1773292279	162 Count	703 Count	150 Count
1773290479	150 Count	650 Count	139 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)