SP9DAT-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9DAT-4. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1757767364	653 Count	738 Count	533 Count
1757765563	604 Count	680 Count	486 Count
1757763776	562 Count	625 Count	446 Count
1757761960	528 Count	579 Count	414 Count
1757761060	505 Count	550 Count	392 Count
1757760159	494 Count	533 Count	382 Count
1757758512	475 Count	500 Count	365 Count
1757757611	459 Count	477 Count	350 Count
1757755810	430 Count	423 Count	323 Count
1757754909	416 Count	404 Count	312 Count
1757754008	407 Count	394 Count	304 Count
1757753108	402 Count	387 Count	300 Count
1757751306	366 Count	321 Count	266 Count
1757750406	357 Count	302 Count	258 Count
1757749505	344 Count	282 Count	246 Count
1757747714	331 Count	256 Count	235 Count
1757745018	317 Count	234 Count	224 Count
1757744118	315 Count	233 Count	223 Count
1757743217	310 Count	229 Count	219 Count
1757742316	305 Count	225 Count	215 Count
1757741416	302 Count	223 Count	213 Count
1757740515	299 Count	221 Count	211 Count
1757739661	296 Count	219 Count	209 Count
1757738714	293 Count	217 Count	207 Count
1757737812	289 Count	214 Count	204 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)