F6ZBY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6ZBY-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1773087475	708 Count	176 Count
1773085673	707 Count	176 Count
1773083872	706 Count	176 Count
1773082072	705 Count	176 Count
1773080271	704 Count	176 Count
1773078470	703 Count	176 Count
1773076669	702 Count	176 Count
1773074869	701 Count	176 Count
1773073068	700 Count	176 Count
1773065876	696 Count	176 Count
1773064075	695 Count	176 Count
1773062275	694 Count	176 Count
1773060473	693 Count	176 Count
1773058672	692 Count	176 Count
1773056872	691 Count	176 Count
1773055071	690 Count	176 Count
1773053270	689 Count	176 Count
1773051469	688 Count	176 Count
1773046076	685 Count	176 Count
1773044275	684 Count	176 Count
1773042474	683 Count	176 Count
1773040673	682 Count	176 Count
1773038873	681 Count	176 Count
1773037072	680 Count	176 Count
1773035271	679 Count	176 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)