SP9VRF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9VRF-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784699743	135 Count	241 Count
1784697943	133 Count	238 Count
1784696142	132 Count	235 Count
1784694341	131 Count	232 Count
1784692541	129 Count	229 Count
1784690740	128 Count	226 Count
1784688940	126 Count	223 Count
1784687139	125 Count	220 Count
1784685338	123 Count	217 Count
1784683542	118 Count	214 Count
1784681742	116 Count	211 Count
1784679941	115 Count	208 Count
1784678141	114 Count	205 Count
1784676340	112 Count	202 Count
1784674539	111 Count	198 Count
1784672739	109 Count	195 Count
1784670937	108 Count	192 Count
1784669137	106 Count	189 Count
1784667336	105 Count	186 Count
1784665536	104 Count	183 Count
1784663735	102 Count	180 Count
1784661953	97 Count	177 Count
1784660140	95 Count	174 Count
1784658340	94 Count	171 Count
1784656539	92 Count	168 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)