REDSPR Telemetry

This is the latest recevied telemetry packets stored in our database for station/object REDSPR. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1780587885	131	1	9	13	112
1780587588	131	1	9	13	112
1780587286	131	1	9	13	112
1780586985	131	0	9	13	112
1780586685	131	1	9	13	113
1780586385	129	1	9	13	112
1780586085	131	1	9	12	113
1780585784	130	1	9	13	112
1780585485	129	1	9	12	113
1780585188	129	1	9	13	112
1780584886	128	0	9	13	112
1780584586	123	1	9	13	112
1780584287	121	1	9	13	113
1780583985	120	1	10	13	113
1780583386	118	1	9	13	112
1780582787	117	1	9	13	112
1780582187	116	1	9	13	112
1780581885	116	1	9	13	112
1780581585	116	1	9	13	112
1780580398	118	1	9	13	113
1780580084	117	1	9	13	113
1780579783	116	1	9	13	112
1780579486	117	1	9	13	112
1780579184	116	1	9	13	112
1780578285	117	1	9	13	113

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)