KQ6DI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1789944585	655	993	1076	503	58
1789943567	655	992	1076	502	57
1789941767	661	980	1067	501	60
1789940985	655	979	1062	500	62
1789939966	645	971	1058	499	60
1789938170	628	941	1022	498	57
1789937385	623	921	1004	497	57
1789936367	607	893	972	496	61
1789934567	580	849	928	495	61
1789933785	575	836	914	494	59
1789932767	564	823	900	493	58
1789930968	558	799	878	492	60
1789930185	548	790	869	491	62
1789929167	537	777	856	490	62
1789927366	526	753	828	489	59
1789926585	526	741	820	488	54
1789925567	505	722	797	487	57
1789923768	489	681	756	486	60
1789922984	483	665	743	485	60
1789921967	472	652	730	484	59
1789920167	462	630	707	483	62
1789919386	456	623	689	482	61
1789918367	456	617	684	481	61
1789916566	451	610	676	480	59
1789915785	451	609	676	479	62

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)