This is the latest recevied telemetry packets stored in our database for station/object SR9NWC. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Temp*
Rx1h*
Tx1h*
Eff1h*
Eff*
1784778580
27 C
430 Pkt
70 Pkt
70 Pcnt
70 Pcnt
1784776778
27 C
410 Pkt
60 Pkt
68 Pcnt
70 Pcnt
1784774976
27 C
390 Pkt
60 Pkt
65 Pcnt
70 Pcnt
1784773175
26.5 C
380 Pkt
70 Pkt
65 Pcnt
70 Pcnt
1784771373
27 C
400 Pkt
70 Pkt
70 Pcnt
70 Pcnt
1784769571
27 C
410 Pkt
70 Pkt
73 Pcnt
70 Pcnt
1784767769
27 C
410 Pkt
70 Pkt
72 Pcnt
70 Pcnt
1784765968
27 C
410 Pkt
70 Pkt
73 Pcnt
70 Pcnt
1784764166
27 C
400 Pkt
70 Pkt
71 Pcnt
70 Pcnt
1784762364
27 C
380 Pkt
80 Pkt
67 Pcnt
70 Pcnt
1784760563
27.5 C
380 Pkt
70 Pkt
65 Pcnt
70 Pcnt
1784758761
27.5 C
390 Pkt
70 Pkt
68 Pcnt
70 Pcnt
1784756959
27.5 C
360 Pkt
70 Pkt
69 Pcnt
70 Pcnt
1784755159
27.5 C
360 Pkt
70 Pkt
71 Pcnt
70 Pcnt
*Used Equation Coefficients:
Temp: 0, 0.5, -64
Rx1h: 0, 10, 0
Tx1h: 0, 10, 0
Eff1h: 0, 1, 0
Eff: 0, 1, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)