SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784693375	226 Count	612 Count	8 Count
1784691575	225 Count	610 Count	8 Count
1784689774	224 Count	608 Count	8 Count
1784687975	223 Count	601 Count	8 Count
1784686174	222 Count	599 Count	8 Count
1784680774	219 Count	593 Count	8 Count
1784678974	218 Count	591 Count	8 Count
1784677173	217 Count	589 Count	8 Count
1784675372	216 Count	587 Count	8 Count
1784673574	215 Count	585 Count	8 Count
1784671773	214 Count	583 Count	8 Count
1784669974	213 Count	581 Count	8 Count
1784668173	212 Count	579 Count	8 Count
1784662772	209 Count	568 Count	8 Count
1784660972	208 Count	566 Count	8 Count
1784659173	207 Count	564 Count	8 Count
1784657372	206 Count	562 Count	8 Count
1784655573	205 Count	560 Count	8 Count
1784653773	204 Count	558 Count	8 Count
1784651973	203 Count	556 Count	8 Count
1784650172	202 Count	554 Count	8 Count
1784648372	201 Count	552 Count	8 Count
1784646571	200 Count	550 Count	8 Count
1784644773	199 Count	543 Count	8 Count
1784642972	198 Count	541 Count	8 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)