F5ZSQ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZSQ-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Vin*	Temp*
1784680250	12.12 Volt	24.5 C
1784584850	12.12 Volt	24.5 C
1784579452	12.12 Volt	25 C
1784354455	12.12 Volt	24 C
1784352655	12.12 Volt	24 C
1784349055	12.12 Volt	24.5 C
1784345458	12.12 Volt	25.5 C
1784343658	12.12 Volt	25.5 C
1784341855	12.12 Volt	26 C
1784340055	12.12 Volt	26.5 C
1784250060	12.12 Volt	27.5 C
1784246460	12.12 Volt	28 C
1784244657	12.12 Volt	28 C
1784241057	12.12 Volt	29 C
1784185259	12.12 Volt	25 C
1784178059	12.12 Volt	25.5 C
1784176259	12.12 Volt	25.5 C
1784174459	12.12 Volt	26 C
1784169059	12.12 Volt	27 C
1784165459	12.12 Volt	27.5 C
1784163659	12.12 Volt	27.5 C
1784152859	12.12 Volt	29 C
1784095260	12.12 Volt	28 C
1784093462	12.12 Volt	28 C
1784089861	12.12 Volt	28.5 C

*Used Equation Coefficients:

Vin: 0, 0.073, 0

Temp: 0, 0.5, -64

A3: 0, 0, 0

A4: 0, 0, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)