SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772863097	37 Count	588 Count	20 Count
1772861895	36 Count	542 Count	20 Count
1772860695	33 Count	503 Count	18 Count
1772858305	24 Count	409 Count	15 Count
1772857104	21 Count	366 Count	13 Count
1772855904	19 Count	325 Count	12 Count
1772854704	17 Count	275 Count	11 Count
1772853503	14 Count	232 Count	9 Count
1772852301	11 Count	191 Count	7 Count
1772851102	9 Count	149 Count	6 Count
1772849901	7 Count	113 Count	5 Count
1772848699	4 Count	68 Count	3 Count
1772847500	2 Count	28 Count	2 Count
1772846299	92 Count	1006 Count	46 Count
1772845097	89 Count	970 Count	44 Count
1772843898	87 Count	946 Count	43 Count
1772842697	85 Count	917 Count	42 Count
1772840294	79 Count	848 Count	38 Count
1772837906	71 Count	796 Count	36 Count
1772836704	68 Count	766 Count	34 Count
1772835505	66 Count	738 Count	33 Count
1772834304	64 Count	695 Count	32 Count
1772833102	61 Count	653 Count	30 Count
1772831903	60 Count	620 Count	30 Count
1772830702	57 Count	573 Count	28 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)