SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785316581	153 Count	375 Count	146 Count
1785314775	140 Count	333 Count	134 Count
1785312970	123 Count	294 Count	118 Count
1785311164	101 Count	248 Count	97 Count
1785309358	78 Count	196 Count	75 Count
1785307553	58 Count	149 Count	56 Count
1785305748	25 Count	91 Count	24 Count
1785303942	11 Count	47 Count	11 Count
1785302137	410 Count	1008 Count	387 Count
1785300331	393 Count	964 Count	371 Count
1785298526	378 Count	907 Count	357 Count
1785296721	356 Count	847 Count	336 Count
1785294915	342 Count	797 Count	323 Count
1785293110	328 Count	747 Count	310 Count
1785291304	314 Count	701 Count	297 Count
1785289499	299 Count	660 Count	283 Count
1785287691	283 Count	614 Count	268 Count
1785285886	267 Count	578 Count	253 Count
1785284080	250 Count	538 Count	237 Count
1785282275	232 Count	506 Count	220 Count
1785280470	215 Count	465 Count	204 Count
1785278664	197 Count	423 Count	187 Count
1785276859	180 Count	384 Count	171 Count
1785275053	164 Count	356 Count	156 Count
1785273248	145 Count	314 Count	138 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)