OE8KKY-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE8KKY-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1765455472	13.43 Volt	3.5 C
1765455172	13.43 Volt	3.5 C
1765454872	13.43 Volt	3.5 C
1765454572	13.43 Volt	3.5 C
1765454272	13.43 Volt	3.5 C
1765453972	13.43 Volt	3.5 C
1765453672	13.43 Volt	3 C
1765453372	13.43 Volt	3 C
1765453072	13.43 Volt	3.5 C
1765452772	13.43 Volt	3 C
1765452472	13.43 Volt	3.5 C
1765452172	13.43 Volt	3 C
1765451872	13.43 Volt	3.5 C
1765451572	13.43 Volt	3 C
1765451272	13.43 Volt	3 C
1765450972	13.43 Volt	3 C
1765450672	13.43 Volt	2.5 C
1765450372	13.43 Volt	2.5 C
1765450072	13.43 Volt	2.5 C
1765449472	13.43 Volt	1.5 C
1765449172	13.43 Volt	2 C
1765448872	13.43 Volt	3 C
1765448572	13.43 Volt	3 C
1765447072	13.43 Volt	2.5 C
1765446172	13.43 Volt	2.5 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

A2: 0, 0, 0

A3: 0, 0, 0

A4: 0, 0, 0

Temp: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)