YC0TBU-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC0TBU-7. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RF->INET*	INET->RF*
1757530461	10 Pkts	0 Pkts
1757529848	11 Pkts	0 Pkts
1757529542	11 Pkts	0 Pkts
1757529236	8 Pkts	0 Pkts
1757526480	8 Pkts	1 Pkts
1757526174	10 Pkts	0 Pkts
1757525868	9 Pkts	0 Pkts
1757525561	7 Pkts	1 Pkts
1757525255	8 Pkts	0 Pkts
1757524949	9 Pkts	0 Pkts
1757524643	9 Pkts	0 Pkts
1757524030	10 Pkts	0 Pkts
1757523417	8 Pkts	0 Pkts
1757521580	9 Pkts	0 Pkts
1757521274	10 Pkts	0 Pkts
1757520355	9 Pkts	0 Pkts
1757519806	9 Pkts	0 Pkts
1757519436	9 Pkts	0 Pkts
1757518517	8 Pkts	0 Pkts
1757517905	7 Pkts	0 Pkts
1757517295	7 Pkts	0 Pkts
1757516989	6 Pkts	1 Pkts
1757516376	7 Pkts	1 Pkts
1757515763	7 Pkts	1 Pkts
1757515151	6 Pkts	1 Pkts

*Used Equation Coefficients:

RF->INET: 0, 1, 0

INET->RF: 0, 1, 0

Repeater: 0, 1, 0

AllCount: 0, 1, 0

AllDrop: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)