SP9LJE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1776673136	522 Count	716 Count	326 Count
1776671335	521 Count	716 Count	326 Count
1776669535	520 Count	716 Count	326 Count
1776667734	519 Count	716 Count	326 Count
1776665933	518 Count	716 Count	326 Count
1776664140	517 Count	716 Count	326 Count
1776662339	505 Count	705 Count	315 Count
1776660538	504 Count	705 Count	315 Count
1776658738	503 Count	705 Count	315 Count
1776656937	502 Count	705 Count	315 Count
1776655137	501 Count	705 Count	315 Count
1776653336	500 Count	705 Count	315 Count
1776651535	499 Count	705 Count	315 Count
1776649735	498 Count	705 Count	315 Count
1776647934	497 Count	705 Count	315 Count
1776646133	496 Count	705 Count	315 Count
1776644333	495 Count	705 Count	315 Count
1776642539	494 Count	705 Count	315 Count
1776640739	493 Count	705 Count	315 Count
1776638938	492 Count	705 Count	315 Count
1776637137	491 Count	705 Count	315 Count
1776635337	490 Count	705 Count	315 Count
1776633536	489 Count	705 Count	315 Count
1776631735	488 Count	705 Count	315 Count
1776629935	487 Count	705 Count	315 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)