XQ3PCN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XQ3PCN-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789954839	5 Count	136 Count
1789953935	4 Count	115 Count
1789953031	3 Count	95 Count
1789952128	2 Count	70 Count
1789951246	1 Count	47 Count
1789950320	0 Count	24 Count
1789949451	46 Count	1004 Count
1789948513	45 Count	981 Count
1789947708	44 Count	953 Count
1789946795	43 Count	910 Count
1789945891	40 Count	846 Count
1789944988	38 Count	803 Count
1789944093	37 Count	755 Count
1789943180	36 Count	715 Count
1789942276	35 Count	673 Count
1789941373	34 Count	632 Count
1789940469	33 Count	597 Count
1789939565	32 Count	550 Count
1789938661	31 Count	490 Count
1789937758	24 Count	451 Count
1789936854	23 Count	417 Count
1789935950	22 Count	365 Count
1789935046	21 Count	332 Count
1789934143	13 Count	289 Count
1789933239	12 Count	243 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)