DL8FAB-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL8FAB-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp*	Humi*
1788676217	21.3 deg C	52.1 %
1788675317	21.4 deg C	53.7 %
1788674417	21.4 deg C	53.6 %
1788673517	21.5 deg C	53.6 %
1788672616	21.5 deg C	53.7 %
1788671716	21.5 deg C	53.8 %
1788671384	21.5 deg C	53.8 %
1788670484	21.5 deg C	53.8 %
1788669584	21.6 deg C	53.8 %
1788668684	21.6 deg C	53.9 %
1788667783	21.6 deg C	53.9 %
1788666883	21.6 deg C	54 %
1788665983	21.7 deg C	54 %
1788665083	21.7 deg C	54.1 %
1788664183	21.8 deg C	54.3 %
1788663283	21.8 deg C	54.5 %
1788662383	21.8 deg C	54.5 %
1788661483	21.9 deg C	54.6 %
1788660583	21.9 deg C	54.7 %
1788659683	21.9 deg C	54.8 %
1788659370	21.9 deg C	54.7 %
1788658470	22 deg C	54.8 %
1788657569	22 deg C	54.8 %
1788656669	22 deg C	54.9 %
1788655769	22.1 deg C	54.9 %

*Used Equation Coefficients:

Temp: 0, 0.1, 0

Humi: 0, 0.1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)