SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772683648	218 Count	991 Count	198 Count
1772682747	195 Count	919 Count	176 Count
1772681847	180 Count	863 Count	162 Count
1772680946	172 Count	759 Count	155 Count
1772680045	158 Count	695 Count	142 Count
1772679145	145 Count	624 Count	130 Count
1772678244	133 Count	569 Count	119 Count
1772677343	127 Count	529 Count	114 Count
1772676442	115 Count	469 Count	103 Count
1772675542	102 Count	415 Count	91 Count
1772674641	96 Count	372 Count	86 Count
1772673740	82 Count	322 Count	73 Count
1772672840	76 Count	273 Count	68 Count
1772671939	52 Count	207 Count	45 Count
1772671038	46 Count	160 Count	40 Count
1772670154	31 Count	110 Count	30 Count
1772669253	15 Count	62 Count	15 Count
1772668352	241 Count	1034 Count	222 Count
1772666551	222 Count	922 Count	205 Count
1772665650	207 Count	869 Count	191 Count
1772664749	184 Count	802 Count	169 Count
1772663870	169 Count	751 Count	155 Count
1772662947	164 Count	702 Count	151 Count
1772662046	152 Count	649 Count	140 Count
1772661146	141 Count	587 Count	130 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)