SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1772667425	7 Count	889 Count
1772665624	5 Count	738 Count
1772663824	4 Count	501 Count
1772662023	2 Count	316 Count
1772660222	1 Count	141 Count
1772658421	0 Count	2 Count
1772656630	51 Count	961 Count
1772654828	43 Count	817 Count
1772653026	10 Count	646 Count
1772651225	4 Count	451 Count
1772649425	2 Count	283 Count
1772647624	0 Count	142 Count
1772645823	26 Count	1126 Count
1772644022	24 Count	858 Count
1772642221	8 Count	696 Count
1772640421	5 Count	527 Count
1772638620	2 Count	285 Count
1772636819	1 Count	131 Count
1772635027	11 Count	1145 Count
1772633226	8 Count	951 Count
1772631425	6 Count	752 Count
1772629625	5 Count	608 Count
1772627824	3 Count	460 Count
1772626023	2 Count	312 Count
1772624222	0 Count	160 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)