DO1CMH-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DO1CMH-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1780549039	0 C deg	14.7 C deg
1780548797	0 C deg	14.8 C deg
1780547191	0 C deg	14.4 C deg
1780545375	0 C deg	14.3 C deg
1780543592	0 C deg	14.2 C deg
1780541777	0 C deg	14.2 C deg
1780540049	0 C deg	14.1 C deg
1780538234	0 C deg	13.8 C deg
1780538114	0 C deg	13.8 C deg
1780536388	0 C deg	13.7 C deg
1780534573	0 C deg	13.8 C deg
1780532736	0 C deg	15.9 C deg
1780530921	0 C deg	15.9 C deg
1780529249	0 C deg	15.7 C deg
1780527434	0 C deg	15.4 C deg
1780527253	0 C deg	15.6 C deg
1780525596	0 C deg	16.4 C deg
1780523781	0 C deg	16.4 C deg
1780521989	0 C deg	16.3 C deg
1780520174	0 C deg	16.1 C deg
1780518403	0 C deg	16.2 C deg
1780518389	0 C deg	16.2 C deg
1780516574	0 C deg	16.9 C deg
1780514793	0 C deg	17.1 C deg
1780512977	0 C deg	17.7 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)