SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773310058	33 Count	469 Count	28 Count
1773304653	17 Count	201 Count	15 Count
1773302853	13 Count	161 Count	12 Count
1773301052	5 Count	132 Count	5 Count
1773299251	147 Count	1014 Count	108 Count
1773297451	142 Count	978 Count	104 Count
1773295655	132 Count	946 Count	99 Count
1773290253	118 Count	846 Count	88 Count
1773288452	111 Count	801 Count	82 Count
1773286652	105 Count	755 Count	77 Count
1773281250	88 Count	642 Count	63 Count
1773275848	73 Count	549 Count	51 Count
1773274055	65 Count	527 Count	48 Count
1773272254	60 Count	500 Count	44 Count
1773268653	51 Count	431 Count	37 Count
1773266852	46 Count	401 Count	33 Count
1773265052	41 Count	376 Count	29 Count
1773259649	25 Count	247 Count	16 Count
1773256048	18 Count	191 Count	11 Count
1773254247	14 Count	139 Count	8 Count
1773250655	4 Count	79 Count	4 Count
1773248855	209 Count	1031 Count	172 Count
1773247054	206 Count	938 Count	170 Count
1773245254	199 Count	858 Count	164 Count
1773243453	193 Count	821 Count	159 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)