PD2ATG-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PD2ATG-5. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1762363119	60 Count	57 Count
1762359519	60 Count	57 Count
1762357719	60 Count	57 Count
1762355919	60 Count	57 Count
1762354119	54 Count	51 Count
1762352319	42 Count	39 Count
1762350518	42 Count	39 Count
1762348718	42 Count	39 Count
1762346918	42 Count	39 Count
1762345117	42 Count	39 Count
1762343319	42 Count	39 Count
1762341519	42 Count	39 Count
1762339719	42 Count	39 Count
1762337919	42 Count	39 Count
1762336119	42 Count	39 Count
1762334319	42 Count	39 Count
1762332519	42 Count	39 Count
1762330719	42 Count	39 Count
1762328919	42 Count	39 Count
1762327118	42 Count	39 Count
1762325318	42 Count	39 Count
1762323518	26 Count	23 Count
1762321716	26 Count	23 Count
1762319916	26 Count	23 Count
1762318116	26 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)