SP9RUT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9RUT-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789965347	4 Count	1044 Count
1789958147	4 Count	839 Count
1789950947	3 Count	646 Count
1789943747	1 Count	425 Count
1789936547	0 Count	198 Count
1789929346	2 Count	1134 Count
1789922146	2 Count	936 Count
1789914946	1 Count	744 Count
1789907746	0 Count	539 Count
1789900546	0 Count	358 Count
1789893346	0 Count	199 Count
1789886146	0 Count	1057 Count
1789878946	0 Count	859 Count
1789871745	0 Count	646 Count
1789864545	0 Count	429 Count
1789857345	0 Count	214 Count
1789850145	0 Count	0 Count
1789842945	7 Count	981 Count
1789835745	7 Count	763 Count
1789828545	4 Count	543 Count
1789821345	0 Count	251 Count
1789814145	1 Count	1052 Count
1789806944	1 Count	829 Count
1789799744	0 Count	619 Count
1789792544	0 Count	429 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)