SQ8BS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8BS-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	V_Bat*
1784691089	82 Count	4.48 VDC
1784690789	79 Count	4.49 VDC
1784690489	76 Count	4.23 VDC
1784690189	71 Count	4.48 VDC
1784689889	60 Count	4.48 VDC
1784689589	49 Count	4.33 VDC
1784689289	31 Count	4.48 VDC
1784688989	19 Count	4.17 VDC
1784688688	11 Count	4.19 VDC
1784688388	3 Count	4.18 VDC
1784688088	2 Count	4.49 VDC
1784687788	1004 Count	4.48 VDC
1784687488	999 Count	4.48 VDC
1784687188	998 Count	4.17 VDC
1784686888	997 Count	4.48 VDC
1784686588	995 Count	4.15 VDC
1784686288	993 Count	4.3 VDC
1784685988	992 Count	4.13 VDC
1784685688	990 Count	4.48 VDC
1784685388	987 Count	4.49 VDC
1784685087	985 Count	4.49 VDC
1784684787	983 Count	4.17 VDC
1784684487	982 Count	4.49 VDC
1784684187	980 Count	4.17 VDC
1784683887	977 Count	4.49 VDC

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)