SV9TNF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV9TNF-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775107031	182 Count	84 Count	84 Count
1775106728	181 Count	84 Count	84 Count
1775106424	180 Count	84 Count	84 Count
1775106120	179 Count	84 Count	84 Count
1775105861	178 Count	84 Count	84 Count
1775105557	177 Count	84 Count	84 Count
1775105253	176 Count	84 Count	84 Count
1775104950	175 Count	84 Count	84 Count
1775104646	174 Count	84 Count	84 Count
1775104342	173 Count	84 Count	84 Count
1775104038	172 Count	84 Count	84 Count
1775103734	171 Count	84 Count	84 Count
1775103430	170 Count	84 Count	84 Count
1775103126	168 Count	83 Count	83 Count
1775102822	166 Count	82 Count	82 Count
1775102519	164 Count	81 Count	81 Count
1775102406	163 Count	81 Count	81 Count
1775102102	161 Count	80 Count	80 Count
1775101845	159 Count	79 Count	79 Count
1775101541	157 Count	78 Count	78 Count
1775101236	155 Count	77 Count	77 Count
1775100933	153 Count	76 Count	76 Count
1775100629	151 Count	75 Count	75 Count
1775100325	149 Count	74 Count	74 Count
1775100021	147 Count	73 Count	73 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)