SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1777066951	24 Count	816 Count
1777066050	22 Count	717 Count
1777065150	19 Count	611 Count
1777064249	17 Count	586 Count
1777063348	13 Count	483 Count
1777062446	11 Count	390 Count
1777061546	8 Count	291 Count
1777060645	6 Count	255 Count
1777059744	1 Count	106 Count
1777058843	33 Count	1077 Count
1777057942	30 Count	946 Count
1777057041	28 Count	913 Count
1777056140	24 Count	829 Count
1777055239	22 Count	739 Count
1777054338	18 Count	602 Count
1777053437	16 Count	573 Count
1777052536	11 Count	481 Count
1777051635	10 Count	380 Count
1777050735	7 Count	252 Count
1777049834	5 Count	212 Count
1777048933	1 Count	123 Count
1777048032	28 Count	1078 Count
1777047131	25 Count	977 Count
1777046230	24 Count	948 Count
1777045329	20 Count	849 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)