SR7U-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7U-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1787340751	73 Count	763 Count	35 Count
1787338950	70 Count	708 Count	33 Count
1787333546	64 Count	624 Count	30 Count
1786866556	43 Count	533 Count	24 Count
1786865737	33 Count	530 Count	24 Count
1786862137	28 Count	461 Count	21 Count
1786860334	26 Count	417 Count	20 Count
1786858535	23 Count	365 Count	18 Count
1786854933	15 Count	271 Count	12 Count
1786853131	11 Count	226 Count	9 Count
1786851331	7 Count	151 Count	6 Count
1786849530	3 Count	83 Count	3 Count
1786847731	292 Count	1031 Count	57 Count
1786845930	288 Count	973 Count	54 Count
1786842330	280 Count	834 Count	48 Count
1786840527	277 Count	764 Count	46 Count
1786838726	275 Count	688 Count	45 Count
1786836925	273 Count	610 Count	44 Count
1786835126	271 Count	557 Count	43 Count
1786831524	267 Count	477 Count	41 Count
1786829724	266 Count	467 Count	41 Count
1786827923	264 Count	432 Count	40 Count
1786826122	262 Count	401 Count	39 Count
1786824327	260 Count	370 Count	38 Count
1786822521	258 Count	340 Count	37 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)