9A1W-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 9A1W-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp I*
1784796201	14.03 Volt	20.5 C
1784795901	14.03 Volt	20.5 C
1784795601	14.03 Volt	20 C
1784795301	14.03 Volt	20 C
1784795001	14.03 Volt	20 C
1784794701	14.03 Volt	20 C
1784794401	14.03 Volt	20 C
1784794101	14.03 Volt	19.5 C
1784793801	14.03 Volt	19.5 C
1784793501	14.03 Volt	19.5 C
1784793201	14.03 Volt	19.5 C
1784792901	14.03 Volt	19.5 C
1784792601	14.03 Volt	19.5 C
1784792301	14.03 Volt	19.5 C
1784792001	14.03 Volt	19 C
1784791701	14.03 Volt	19 C
1784791401	14.03 Volt	19 C
1784791101	14.03 Volt	19 C
1784790801	14.03 Volt	19 C
1784790501	14.03 Volt	19 C
1784790201	14.03 Volt	18.5 C
1784789901	14.03 Volt	18.5 C
1784789608	14.03 Volt	18.5 C
1784789301	14.03 Volt	18.5 C
1784789003	14.03 Volt	18.5 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

V AC: 0, 0.075, 0

Temp I: 0, 0.5, -64

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)