SP8MB-L Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8MB-L. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761559300	335 Count	40 Count	40 Count
1761559179	334 Count	40 Count	40 Count
1761559058	333 Count	40 Count	40 Count
1761558938	332 Count	40 Count	40 Count
1761558696	329 Count	39 Count	39 Count
1761558575	328 Count	39 Count	39 Count
1761558332	326 Count	39 Count	39 Count
1761558211	325 Count	39 Count	39 Count
1761557970	323 Count	39 Count	39 Count
1761557849	322 Count	39 Count	39 Count
1761557728	320 Count	38 Count	38 Count
1761557607	319 Count	38 Count	38 Count
1761557486	318 Count	38 Count	38 Count
1761557365	317 Count	38 Count	38 Count
1761557244	316 Count	38 Count	38 Count
1761557124	315 Count	38 Count	38 Count
1761557003	314 Count	38 Count	38 Count
1761556882	312 Count	37 Count	37 Count
1761556761	311 Count	37 Count	37 Count
1761556640	310 Count	37 Count	37 Count
1761556519	309 Count	37 Count	37 Count
1761556398	308 Count	37 Count	37 Count
1761556278	307 Count	37 Count	37 Count
1761556157	306 Count	37 Count	37 Count
1761556036	305 Count	37 Count	37 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)