DB0KK-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DB0KK-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Volt*	Ampere*
1787582627	12.6 V	2408 A
1787580812	12.5 V	3515 A
1787578997	12.6 V	2421 A
1787577182	12.6 V	2456 A
1787575367	12.6 V	2198 A
1787491389	12.6 V	2356 A
1787489574	12.6 V	2318 A
1787487759	12.6 V	2349 A
1787486066	12.6 V	2369 A
1787398004	12.6 V	2464 A
1787398004	12.6 V	2464 A
1787396189	12.6 V	2394 A
1787396189	12.6 V	2394 A
1787394375	12.6 V	2462 A
1787394375	12.6 V	2462 A
1787392559	12.6 V	2372 A
1787392559	12.6 V	2372 A
1787310716	12.6 V	2400 A
1787310716	12.6 V	2400 A
1787308808	12.5 V	3476 A
1787308808	12.5 V	3476 A
1787306993	12.6 V	2349 A
1787306993	12.6 V	2349 A
1787305178	12.6 V	2346 A
1787305178	12.6 V	2346 A

*Used Equation Coefficients:

Volt: 0, 1, 0

Ampere: 0, 1, 0

Batt: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)