ON2ACO-0 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON2ACO-0. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RFIn*	V1*	Temp*
1761482963	1155 Pkts	5 V	17 C
1761435498	475 Pkts	5 V	13 C
1761421099	849 Pkts	5 V	16 C
1761380049	1150 Pkts	5 V	14 C
1761365649	858 Pkts	5 V	13 C
1761351249	618 Pkts	5 V	14 C
1761322449	1373 Pkts	5 V	16 C
1761308049	1166 Pkts	5 V	13 C
1761293648	838 Pkts	5 V	10 C
1761279248	861 Pkts	5 V	14 C
1761264849	770 Pkts	5 V	13 C
1761250449	459 Pkts	5 V	17 C
1761236049	908 Pkts	5 V	14 C
1761221649	879 Pkts	5 V	13 C
1761207249	536 Pkts	5 V	12 C
1761192849	685 Pkts	5 V	15 C
1761178449	481 Pkts	5 V	16 C
1761164049	223 Pkts	5 V	18 C
1761149649	987 Pkts	5 V	16 C
1761135249	787 Pkts	5 V	15 C
1761120849	620 Pkts	5 V	14 C
1761106449	569 Pkts	5 V	15 C
1761092049	482 Pkts	5 V	15 C
1761065237	484 Pkts	5 V	15 C
1760734037	1002 Pkts	5 V	17 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

V1: 0, 0.1, 0

Temp: 0, 1, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)