This is the latest recevied telemetry packets stored in our database for station/object SP0PQB-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
TX*
RX*
Digi*
V_Bat*
V_Ext*
1784772916
332 Count
676 Count
0 Count
4.05 VDC
0 VDC
1784771113
331 Count
661 Count
0 Count
4.06 VDC
0 VDC
1784769310
330 Count
647 Count
0 Count
4.06 VDC
0 VDC
1784765703
328 Count
615 Count
0 Count
4.08 VDC
0 VDC
1784763899
327 Count
597 Count
0 Count
4.08 VDC
0 VDC
1784762096
326 Count
579 Count
0 Count
4.08 VDC
0 VDC
1784760292
325 Count
565 Count
0 Count
4.09 VDC
0 VDC
1784758489
324 Count
547 Count
0 Count
4.1 VDC
0 VDC
1784756686
323 Count
531 Count
0 Count
4.1 VDC
0 VDC
1784756563
318 Count
530 Count
0 Count
4.1 VDC
0 VDC
1784755258
303 Count
515 Count
0 Count
4.11 VDC
0 VDC
1784751652
301 Count
486 Count
0 Count
4.11 VDC
0 VDC
*Used Equation Coefficients:
TX: 0, 1, 0
RX: 0, 1, 0
Digi: 0, 1, 0
V_Bat: 0, 0.01, 0
V_Ext: 0, 0.02, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)