DL1MPL-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1MPL-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1785296233	0 C deg	27.4 C deg
1785294403	0 C deg	27.6 C deg
1785292573	0 C deg	27.7 C deg
1785290743	0 C deg	27.9 C deg
1785288913	0 C deg	28.1 C deg
1785287083	0 C deg	28.2 C deg
1785285253	0 C deg	28.5 C deg
1785283423	0 C deg	28.7 C deg
1785281593	0 C deg	28.9 C deg
1785279762	0 C deg	29.1 C deg
1785277932	0 C deg	29.4 C deg
1785276102	0 C deg	29.6 C deg
1785274272	0 C deg	29.8 C deg
1785272442	0 C deg	30.1 C deg
1785270612	0 C deg	30.3 C deg
1785268790	0 C deg	30.5 C deg
1785268782	0 C deg	30.5 C deg
1785266952	0 C deg	30.8 C deg
1785265122	0 C deg	31.1 C deg
1785263292	0 C deg	31.3 C deg
1785261462	0 C deg	31.4 C deg
1785259632	0 C deg	31.8 C deg
1785257802	0 C deg	31.8 C deg
1785255972	0 C deg	31.8 C deg
1785254142	0 C deg	31.7 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)