SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788610207	17 Count	122 Count	10 Count
1788609907	15 Count	109 Count	9 Count
1788609606	14 Count	94 Count	9 Count
1788609333	12 Count	79 Count	8 Count
1788609005	7 Count	61 Count	4 Count
1788608705	4 Count	43 Count	2 Count
1788608404	2 Count	27 Count	1 Count
1788608103	1 Count	14 Count	1 Count
1788607802	333 Count	1010 Count	211 Count
1788607502	331 Count	995 Count	210 Count
1788607201	328 Count	980 Count	208 Count
1788606900	325 Count	971 Count	206 Count
1788606601	323 Count	965 Count	205 Count
1788606299	321 Count	958 Count	204 Count
1788605999	319 Count	943 Count	203 Count
1788605698	317 Count	927 Count	202 Count
1788605397	314 Count	911 Count	200 Count
1788605096	310 Count	893 Count	197 Count
1788604796	308 Count	876 Count	196 Count
1788604195	304 Count	854 Count	194 Count
1788603894	302 Count	849 Count	193 Count
1788603594	299 Count	841 Count	191 Count
1788603292	293 Count	830 Count	186 Count
1788602991	291 Count	823 Count	185 Count
1788602691	289 Count	817 Count	184 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)