EB5CGD-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5CGD-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765538420	16 Count	806 Count
1765537220	16 Count	804 Count
1765536021	16 Count	804 Count
1765534821	16 Count	804 Count
1765533621	16 Count	804 Count
1765532421	16 Count	804 Count
1765531220	16 Count	804 Count
1765530020	16 Count	804 Count
1765527620	16 Count	804 Count
1765526420	16 Count	804 Count
1765525220	16 Count	804 Count
1765524020	16 Count	804 Count
1765522820	16 Count	804 Count
1765521620	16 Count	804 Count
1765520420	16 Count	804 Count
1765519220	16 Count	804 Count
1765518020	16 Count	804 Count
1765516819	16 Count	804 Count
1765515619	16 Count	804 Count
1765473613	16 Count	804 Count
1765472413	16 Count	804 Count
1765471214	16 Count	804 Count
1765467614	16 Count	804 Count
1765466414	16 Count	804 Count
1765465214	16 Count	804 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)