S51W-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S51W-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1761505809	13.71 Volt	66 Pcnt
1761504908	13.71 Volt	50 Pcnt
1761504007	13.71 Volt	25 Pcnt
1761503106	13.71 Volt	40 Pcnt
1761499503	13.71 Volt	38 Pcnt
1761498602	13.71 Volt	55 Pcnt
1761497701	13.71 Volt	100 Pcnt
1761496800	13.71 Volt	100 Pcnt
1761495899	13.71 Volt	100 Pcnt
1761494998	13.71 Volt	100 Pcnt
1761494108	13.71 Volt	100 Pcnt
1761493196	13.71 Volt	100 Pcnt
1761492300	13.71 Volt	100 Pcnt
1761491395	13.71 Volt	100 Pcnt
1761490494	13.71 Volt	50 Pcnt
1761489593	13.71 Volt	40 Pcnt
1761488692	13.71 Volt	40 Pcnt
1761486890	13.71 Volt	75 Pcnt
1761485990	13.71 Volt	100 Pcnt
1761485091	13.63 Volt	100 Pcnt
1761485089	13.63 Volt	100 Pcnt
1761484188	13.71 Volt	100 Pcnt
1761483287	13.71 Volt	100 Pcnt
1761482386	13.71 Volt	100 Pcnt
1761481485	13.71 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.077, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)