HB9EVW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9EVW-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1788714533	901 Count	324 Count
1788712733	900 Count	324 Count
1788710933	897 Count	321 Count
1788709133	897 Count	321 Count
1788707333	897 Count	321 Count
1788705533	897 Count	321 Count
1788703733	895 Count	321 Count
1788701933	895 Count	321 Count
1788700132	895 Count	321 Count
1788698332	895 Count	321 Count
1788696532	894 Count	321 Count
1788694732	894 Count	321 Count
1788692932	894 Count	321 Count
1788691132	894 Count	321 Count
1788689332	893 Count	321 Count
1788687532	893 Count	321 Count
1788685732	893 Count	321 Count
1788683931	893 Count	321 Count
1788682131	893 Count	321 Count
1788680331	893 Count	321 Count
1788678531	893 Count	321 Count
1788676731	893 Count	321 Count
1788674931	892 Count	321 Count
1788673131	892 Count	321 Count
1788671331	892 Count	321 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)