SP7THR-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7THR-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	V_Batt*	Value3*	Value4*	Value5*
1754038483	0.01 VDC	179	37	134
1754037233	0 VDC	179	37	132
1754035983	0.01 VDC	179	37	131
1754034760	0 VDC	179	37	130
1754033504	0 VDC	179	37	130
1754032254	0 VDC	179	37	131
1754029756	0 VDC	179	37	129
1754028507	0 VDC	179	37	133
1754027256	0 VDC	179	37	132
1754026006	0 VDC	179	37	129
1754024756	0 VDC	179	37	129
1754023507	0 VDC	179	37	130
1754022257	0 VDC	179	37	128
1754021007	0 VDC	179	37	128
1754019757	0 VDC	179	37	127
1754018509	0 VDC	179	37	127
1754017260	0 VDC	179	37	126
1754016013	0 VDC	179	37	126
1754014765	0 VDC	180	37	127
1754013516	0 VDC	180	37	126
1754012267	0 VDC	180	37	126
1754011018	0 VDC	180	37	127
1754009770	0 VDC	180	37	126
1754008521	0 VDC	180	37	126
1754006023	0 VDC	180	37	126

*Used Equation Coefficients:

V_Batt: 0, 0.01, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)