HS6XHH-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS6XHH-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1753637631	12.56 Volt	0 Pcnt
1753635831	12.56 Volt	0 Pcnt
1753634031	12.56 Volt	0 Pcnt
1753632231	12.56 Volt	0 Pcnt
1753630431	12.56 Volt	0 Pcnt
1753628631	12.56 Volt	0 Pcnt
1753626831	12.56 Volt	0 Pcnt
1753625031	12.56 Volt	0 Pcnt
1753623231	12.56 Volt	0 Pcnt
1753621431	12.56 Volt	0 Pcnt
1753617831	12.56 Volt	0 Pcnt
1753616031	12.56 Volt	0 Pcnt
1753614231	12.56 Volt	0 Pcnt
1753608832	12.56 Volt	0 Pcnt
1753607032	12.56 Volt	0 Pcnt
1753605232	12.56 Volt	0 Pcnt
1753603432	12.56 Volt	0 Pcnt
1753601632	12.56 Volt	33 Pcnt
1753599832	12.56 Volt	50 Pcnt
1753598032	12.56 Volt	50 Pcnt
1753596232	12.56 Volt	21 Pcnt
1753594432	12.56 Volt	20 Pcnt
1753592632	12.56 Volt	50 Pcnt
1753590832	12.56 Volt	25 Pcnt
1753589032	12.56 Volt	17 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.079, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)