WA6ODP-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WA6ODP-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1784690988	10.23	504.59	542	849
1784690773	10.23	508.11	548	853
1784689189	10.23	530.08	558	880
1784688974	10.26	532.72	569	884
1784687392	10.23	552.94	580	911
1784687174	10.17	554.7	596	913
1784685592	10.23	573.16	601	934
1784685374	10.23	577.55	601	934
1784683793	10.2	612.71	634	968
1784683574	10.23	617.98	634	977
1784681994	10.2	637.32	650	1022
1784681775	10.2	639.08	645	1023
1784680194	10.2	651.39	650	1033
1784679974	10.2	653.14	661	1037
1784678396	10.2	663.69	666	1056
1784678175	10.2	663.69	666	1061
1784676597	10.2	675.12	677	1080
1784676374	10.23	676	666	1083
1784674797	10.17	677.76	677	1108
1784674575	10.23	676.88	677	1108
1784672998	10.2	665.45	666	1103
1784672774	10.17	662.81	666	1101
1784671199	10.2	646.11	655	1082
1784670975	10.2	644.35	650	1080
1784669401	10.23	636.44	645	1066

*Used Equation Coefficients:

Value1: 0, 0.0293, 0

Value2: 0, 0.879, -459.67

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)