This is the latest recevied telemetry packets stored in our database for station/object DJ6RG-21. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Press*
Temp.in*
Hum*
QNH*
Temp.out*
1776667502
1004.4 hPa
22.2 C deg
34.3 %
1021.9 hPa
11.5 C deg
1776667473
1004.3 hPa
22.2 C deg
34.4 %
1021.9 hPa
11.4 C deg
1776667275
1004.3 hPa
22.2 C deg
34.4 %
1021 hPa
11.4 C deg
1776666864
1004.4 hPa
22.2 C deg
34.6 %
1021.9 hPa
10.4 C deg
1776666862
1004.4 hPa
22.2 C deg
34.6 %
1021.9 hPa
10.4 C deg
1776666590
1004.4 hPa
22.1 C deg
34.7 %
1021.9 hPa
9.8 C deg
1776665955
1004.5 hPa
21.8 C deg
35.3 %
1020.5 hPa
9 C deg
1776665924
1004.5 hPa
21.8 C deg
35.3 %
1020.5 hPa
9 C deg
1776665341
1004.4 hPa
22.4 C deg
34.4 %
1020.8 hPa
7.6 C deg
1776665303
1004.4 hPa
22.4 C deg
34.4 %
1020.8 hPa
7.6 C deg
1776665053
1004.4 hPa
22.4 C deg
34.4 %
1020.8 hPa
7.6 C deg
*Used Equation Coefficients:
Press: 0, 1, 0
Temp.in: 0, 1, 0
Hum: 0, 1, 0
QNH: 0, 1, 0
Temp.out: 0, 1, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)