SN2DP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SN2DP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765543001	281 Count	307 Count	182 Count
1765542100	280 Count	307 Count	182 Count
1765541199	279 Count	307 Count	182 Count
1765540314	275 Count	304 Count	179 Count
1765539413	271 Count	301 Count	176 Count
1765538512	266 Count	297 Count	172 Count
1765537612	264 Count	295 Count	171 Count
1765536711	263 Count	295 Count	171 Count
1765535811	260 Count	293 Count	169 Count
1765534910	258 Count	291 Count	168 Count
1765534009	256 Count	289 Count	167 Count
1765533109	254 Count	287 Count	166 Count
1765532208	252 Count	282 Count	165 Count
1765531307	247 Count	278 Count	161 Count
1765530407	244 Count	276 Count	159 Count
1765529506	241 Count	274 Count	157 Count
1765526804	232 Count	266 Count	151 Count
1765525017	224 Count	259 Count	145 Count
1765524102	221 Count	256 Count	143 Count
1765523202	217 Count	252 Count	140 Count
1765522301	213 Count	245 Count	137 Count
1765521400	208 Count	240 Count	133 Count
1765520500	205 Count	236 Count	131 Count
1765519599	202 Count	233 Count	129 Count
1765518714	197 Count	226 Count	125 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)