SV3GCB-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV3GCB-14. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788427924	49 Count	46 Count	24 Count
1788427019	47 Count	44 Count	23 Count
1788426114	45 Count	42 Count	22 Count
1788425208	43 Count	40 Count	21 Count
1788424303	41 Count	38 Count	20 Count
1788423398	39 Count	36 Count	19 Count
1788422493	37 Count	34 Count	18 Count
1788421587	35 Count	32 Count	17 Count
1788420804	30 Count	31 Count	17 Count
1788419913	28 Count	29 Count	16 Count
1788418994	26 Count	27 Count	15 Count
1788418089	24 Count	25 Count	14 Count
1788417184	22 Count	23 Count	13 Count
1788416286	20 Count	21 Count	12 Count
1788415373	18 Count	19 Count	11 Count
1788414468	16 Count	17 Count	10 Count
1788413573	13 Count	14 Count	8 Count
1788412657	11 Count	12 Count	7 Count
1788411752	9 Count	10 Count	6 Count
1788410847	7 Count	8 Count	5 Count
1788409942	5 Count	6 Count	4 Count
1788409038	3 Count	4 Count	3 Count
1788408132	1000 Count	950 Count	574 Count
1788407226	996 Count	944 Count	571 Count
1788405416	975 Count	918 Count	552 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)